If you have a shower door that is more than an inch from the floor, you can find shower door bottom seals that will fit but they are not as readily available. If your custom shower door has a large gap in between the door and the floor, you may need to measure the depth (size of the space in between the door and floor) and order the correct seal or sweep. Most of the shower door seals available are not deep assuming the shower door was measured correctly and has a small gap (11/32) from the door to the floor. This will tell you how thick the glass is and you can order the correct replacement seal. Use a tape measure and measure the thickness of the door. Most custom shower doors are from 3/8, 1/4, or 1/2 inches thick. When buying a replacement shower door bottom seal, be sure you measure the thickness of the glass. This can be a safety issue as the bathroom floor can become slippery and cause accidents. Without this seal, water will leak from the shower, under the shower door, and onto the floor. The “lip” or “drip edge” on the seal points toward the shower. The seal has a small lip on the side of it to block water. This seal mounts onto the bottom of the shower door to block the water from leaking out. The shower door seal installs by sliding it onto the bottom of the shower door. This seal is usually clear vinyl plastic and is on average installed without any silicone or special tools. This seal stops shower leaks and creates a water barrier. The part you need to fix your shower door is called a Frameless Shower Door Bottom Seal or Sweep. If you have water that is leaking on the floor in your custom shower, the shower door bottom seal might be missing, damaged, or not properly installed. How To Replace Plastic Seal At Bottom Of A Shower Door What is this piece called and how do I install it? When taking showers the water from inside the shower leaks onto the bathroom floor. The clear plastic bottom seal or sweep that keeps the water off the bathroom floor has fallen apart. The glass is either 3/8 or 1/4 inches thick. However, the basic rule is to replace your shower door wipes and seals after every 1-2 years or, if your shower door sweep is damaged, cracked, or brittle, then it’s time for you to replace it.Ĭlick any links on this blog to be redirected to some of our many shower accessory solutions.How do I remove and replace the seal at the bottom of my shower door? I have a custom glass shower door that leaks water at the bottom. Replacing shower door wipe and seal is fairly an easy “do it yourself” project, as long as you are careful to buy the right one.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |